The proper model selection for a SECTIONAL vulcanizer depends on determining dimensions A and B(see diagram at right).  

A-the platen length (A)is calculated by adding to the the belt manufacturer’s recommended splice length

6 inches (150 mm) for fabric belt    

8 inches (205 mm) for finger splice   

14 inches (355 mm) for steelcord belt

B-the platen width (B) which includes the bias angle,is determined by adding to the belt width

6 inches (150 mm) for fabric belt   

8 inches (200 mm) for steelcord belt

To this figure multiply by:

1.07 for 22 degree bias angle

1.05 for 17 degree bias angle

Dimensions A and B represent the outside platen dimensions. Scan down the list below until you arrive at a platen size that corresponds with your calculations.

If the size you require is not listed below our Sales department will be happy to recommend a suitable size. Custom sizes, rectangular configurations and multiple  platen arrangements are also available upon request.

The following is only a small sampling of Sectional vulcanizing presses available from EPNUO.

Custom sizes, rectangular configurations, multiple platen arrangements or models for higher operating pressure available on request. Contact us or your local representative for more information.

100 PSI (7 kg/cm sq.) units suitable for splicing fabric ply belting.

Specifications are subject to change without notice.

Integral cooling standard on all units.

Total weights include electrical control panel, cable sets and set-up templates for all models.

Temperature adjustable between 200 - 365 deg. F (93 - 185 deg. C). ·

Sectional vulcanizers are built on a 22 degree bias with a left hand lead.