Solution to common problems of conveyor belt vulcanizer

To solve the common problems of the conveyor belt vulcanizer, if the pressure does not rise when the manual pump is used for pressurizing, check whether the water inlet of the water pressure plate is pressed due to the over tightening of the frame bolts. In this case, loosen the bolts properly. In addition, check whether the manual pump has air leakage or all joints are loose, and fasten them, and check whether the gasket of the hydraulic pump is damaged. Some users found that the adhesive tape was bonded with the heating plate after vulcanization. The reason for this problem is that the user did not pad newspaper or talcum powder between the upper and lower heating plates according to the operation requirements during use. It is caused by direct contact between the heating plate and the conveyor belt. After this problem occurs, it is only necessary to clean the heating plate. In the next use process, it will not occur again in strict accordance with the operating procedures.

Vulcanizacion en plastic、Vulcanizacion en textile、Vulcanizador