How to master the operating skills of the curing press?

How to master the operating skills of the curing press? For those who just come into contact with the curing press, they may not know how to use the curing press. It is not easy to quickly master the operating skills of the curing press. As the saying goes, practice makes perfect. In addition to more practice, the following points should also be noted:

1. All molds must be placed in the center when they are placed on the flat plate. Gloves shall be worn when delivering the molds to prevent scalding.

2. When sticking the test piece to the mold, be careful when opening the mold to prevent it from falling to the ground.prensa、prensa hidraulica、vulcanizing tools and equipments、conveyor belt

3. Adjust the pressure gauge according to the die size and the specified unit pressure. Overpressure vulcanization is strictly prohibited.

4. It is forbidden to accumulate uneven plates in the flat plate.

5. The protective rubber plate must be padded when cutting the sample with vulcanized plate.

6. In case of equipment failure, the power supply must be cut off before handling.

7. When taking the test piece from the mold, pay attention to the mold cavity and the smooth surface of the mold to prevent scratches.

8. It is strictly forbidden to take the mold or clean up the sundries when the plate is rising.

9. It is not allowed to use the flat curing press beyond the specified temperature.

10. When not in use, cut off the power supply, put down the pressure and close the oil valve.

The above is the introduction to the operating skills of the curing press. The curing press focuses on its use and maintenance. Good operating habits and skilled operating skills can greatly improve the service life of the curing press, so it is important to master the operating skills of the curing press.