Vulcanizer -What are the common problems withConveyor belt splices ?

Due to improper use or improper storage in daily work, some small problems may occur in the vulcanization machine. The vulcanization machine manufacturer should promptly solve these small problems to avoid affecting the normal use of the machine. After the vulcanization work is completed on the vulcanizing machine, there may sometimes be a phenomenon of adhesive tape sticking to the heating plate.

The reason for this problem may be that during the use of the vulcanizing machine, isolation materials such as newspapers or talcum powder were not placed between the upper and lower heating plates according to the operating requirements, which can easily cause this problem. Once this problem occurs, timely cleaning of the heating plate is sufficient, and then more attention should be paid to it in the next use.

When using a manual pump to pressurize, there may be times when the pressure does not rise. When encountering this situation, it is necessary to inspect the water inlet of the water pressure plate and the manual pump. Once problems are found, they must be promptly resolved. From the outside, there may be situations where the heating process becomes longer or the temperature cannot reach 145 ℃ after the vulcanization machine is working. At this time, it is necessary to inspect the insulation board and observe whether it is caused by the dampness of the insulation board.

If the temperature cannot be raised, it is necessary to check the vulcanization time switch in the upper left corner of the control box to see if it is turned on. If it is turned on, it should be turned off, otherwise it will remain in the insulation state. For the problem of joints that cannot be tightly bonded due to uneven temperature on the heating plate of the vulcanization machine, it is necessary to check whether the insulation plate is damaged. If the insulation plate is intact, the heating plate can be heated separately, and then a thermometer can be used to measure the temperature of each part of the heating plate.

Vulcanizing presses  #Vulcanizing press #Conveyor belt vulcanizers #Vulcanizer #Hot vulcanizing machine #Vulcanizing machine#Vulcanizer machine#Conveyor belt splices #Vulcanizador #Prensa Vulcanizador