Vulcanizing presses Conveyor belt

How is the maintenance and upkeep of the belt vulcanizer carried out?

Do not use the curing machine in the wild on rainy days to prevent the flow of electric control boxes and heating plates. When disassembling and transporting the vulcanizing machine in a humid working environment with plenty of water, it is necessary to support it with high objects on the ground and avoid direct contact with water. If the belt vulcanizer does not require a long time, it should be heated once every half month, with a temperature setting of 100 to maintain the temperature for about 30 minutes.

Improper operation and water ingress during use should be repaired by contacting the manufacturer first. If emergency maintenance is required, the board cover can be opened, water poured first, and then the electrical control box can be set to manual operation. Heat it to 100, maintain a constant temperature for 30 minutes, dry the circuit, and bond the belt in manual mode. At the same time, it is necessary to promptly contact the production enterprise and change the overall route.

After each use, it is necessary to drain the water inside the water pressure thoroughly. Especially in winter, if water cannot be drained clean, rubber often ages too early and its lifespan decreases. The correct drainage method is after the vulcanization insulation is completed and before the vulcanization machine decomposes. After disassembling the machine, add water, and the water in the water pressure may not be completely discharged.

Vulcanizing presses  #Vulcanizing press #Conveyor belt vulcanizers #Vulcanizer #Hot vulcanizing machine #Vulcanizing machine#Vulcanizer machine#Conveyor belt splices #Vulcanizador #Prensa Vulcanizador