Which places require the use of vulcanizing machines?

Vulcanizing machine is a machine that vulcanizes various rubber and plastic materials, with functions such as timed mold locking, automatic pressure filling, automatic temperature control, automatic timing, and alarm upon arrival. The vulcanization machine manufacturer introduces three forms of vulcanization machine heating: electric heating, steam heating, and thermal oil heating. The vulcanizing machine is used to solidify the adhesive, which is actually a heating device.

If it is silicone used on tires, it must be fluorosilicone compound. fluorosilicone compound cannot cure at room temperature and must be heated and vulcanized. Silicone rubber can be cured at room temperature, which is a single or two component silicone rubber. The lifting limit of the vulcanizing machine is to prevent the main cylinder from rising beyond its stroke, which is generally not exceeded. Once it exceeds the limit, the main cylinder will detach and oil will spray out from the oil seal.

The lowering limit of the vulcanizing machine is to prevent a collision sound when the main cylinder drops to the bottom, so the lower limit will be adjusted to prevent it from hitting the bottom. Most customers require efficiency, as the rise and fall distance will affect each mold cycle, so the lower limit is usually set to the mold that can be opened. When the vulcanizing machine is working, the lifting cylinder drives the upper mold to rise along the guide column, forming a cavity inside the frame. The tire loading device rotates into the tire, and the upper and lower rings of the central mechanism rise, positioning the tire embryo.

unloading the tire, the tire loading device exits, and the lifting oil cylinder drives the upper mold to descend along the guide column to close the mold. After the tire embryo is shaped, the mold is closed in place. During operation, it is not allowed to use a flat vulcanizing machine beyond the specified temperature. The equipment has a malfunction and must be cut off before handling it. When closing the mold, hands should leave the vulcanization mold and it is strictly prohibited to operate while closing the mold. Wear gloves when delivering molds to prevent burns. When sticking the sample to the mold, be careful to hit your hands when opening the mold to prevent it from falling to the ground.

Before use, the insulation resistance of the hot plate should be checked. If it is too low, it should be dried with electricity until the insulation value reaches below 50MPa before use. During the use and transportation process, it should be handled with care and handled in a civilized manner. If working in the field, reliable rainproof and waterproof measures are required to avoid being affected by rain and moisture. After use, it should be placed in a well ventilated warehouse with a relative humidity of not more than 85% and not affected by rain. Sleepers should be placed underneath, and it is strictly prohibited to place it on the ground.

The vulcanization machine generally consists of four parts: a clamping mechanism, a control system, a three pressure system, and a four heating system. The clamping mechanism is generally composed of a frame and bolts, the control system is composed of an electric control box and primary and secondary wires, the pressure system is composed of a water pressure plate and a pressure testing pump, and the heating system is composed of a heating plate and an insulation plate.Vulcanizing presses  #Vulcanizing press #Conveyor belt vulcanizers #Vulcanizer #Hot vulcanizing machine #Vulcanizing machine#Vulcanizer machine#Conveyor belt splice