What should be done after the conveyor belt vulcanizer collides and seeps water?

The emergence of conveyor belt vulcanization machines is suitable for use in the vulcanization process of various rubber products, and is also a hot pressing equipment for pressing and forming various thermosetting plastics. The conveyor belt vulcanization machine can be divided into electric heating, steam heating, and thermal oil heating according to the heating method. In general, the material and performance of the vulcanizing machine itself are very excellent.

When there is a slight collision, there is generally no excessively serious malfunction. Once the collision is severe, the vulcanizing machine is prone to water seepage. At this time, it is necessary to stop the machine for inspection in a timely manner to avoid causing greater harm to the vulcanizing machine due to water seepage. Due to improper storage or collision during use, the water pressure plate of the vulcanizing machine may leak water, and it should be inspected according to the steps.

For example, check the water seepage area, whether it is the surface of the water pressure plate or the contact ground between the surrounding rubber and the lower plate of the water pressure plate. If there is water leakage in the gaps around, tighten all the screws around in sequence. If the leakage is on the surface of the water pressure plate rubber and the leakage is needle shaped, materials such as 520 glue can be used for repair in case of emergency repair. However, after the repair is completed, the panel needs to be replaced in a timely manner.

When severe water leakage occurs and the vulcanization machine cannot reach normal operating conditions, the water pressure plate needs to be replaced. A normal vulcanizing machine can ensure product quality, provide production efficiency, and enable enterprises to achieve economic benefits under its name. As a conveyor belt joint tool, effective maintenance and upkeep must be carried out during and after use to extend the overall service life.

When transporting the conveyor belt vulcanization machine, it is recommended to use handling equipment as much as possible. If steel pipes are used for handling, their diameter should not exceed 60mm. The machine should not be excessively tilted to prevent accidents and not damage various components and surface paint. The vulcanizing machine needs to be placed on a stable and sturdy foundation, and the vertical and horizontal levels should be corrected with a level gauge. Add pure 68 # anti wear hydraulic oil to the oil tank, and the oil level should reach the upper mark of the oil level gauge. After one trial run, it needs to be supplemented.

When starting the vulcanization machine, users must follow the corresponding operating standards to avoid operating errors that affect the use and performance of the equipment, and also to avoid damage caused by improper equipment operation.Vulcanizing presses  #Vulcanizing press #Conveyor belt vulcanizers #Vulcanizer #Hot vulcanizing machine #Vulcanizing machine#Vulcanizer machine#Conveyor belt splices