The vulcanizer has the advantages of small volume, half weight reduction, low energy consumption, fast heating, etc. After heating, the whole board surface has considerable flexibility, which is closer to the tape than traditional machines. Under the pressure of 1.5 MPa, the parallel tightness shall not be greater than 0.03mm. Generally speaking, traditional machines do not have this performance.

2. The upper and lower heating plates of the vulcanizer provide uniform heat supply. Ten minutes after entering the heat preservation stage, the temperature difference at each point of the working face is only 6550.

3. It takes less than 25 minutes to rise from room temperature to vulcanization temperature (145 ℃), and the power is half lower than that of the same industry at home and abroad. Good energy-saving effect.

4. Vulcanized rubber or repair shall be molded at one time, and the bonding part shall be smooth and smooth, with the same fastness as the original belt.

5. The upper and lower heating plates of the vulcanizer are a trinity, with simple structure and convenient installation.

According to the understanding of the belt vulcanizer, the upper and lower characteristics of the vulcanizer have five advantages that other machines can not compare.

Belt curing press Jpg belt vulcanizer is applicable to the separation of various cloth core, steel wire core conveyor belts from rubber coated and canvas, rubber coated and steel wire rope, canvas;

1. Before use, the insulation resistance of the hot plate must be checked. If it is too low, it should be energized and dried until the insulation value is less than 50MPa.

2. In the process of use, it should be light, light and civilized;

3. In case of field operation, reliable means of rain and waterproof shall be provided to avoid being exposed to rain.

4. When in use, it should be placed in the air circulation, with the relative humidity not greater than 85%, and not affected by the rain bin. It is strictly prohibited to put it directly on the ground under the pillow.

5. Tighten and tighten.prensa、prensa hidraulica、vulcanizing tools and equipments、conveyor belt

6. Connect the power supply and electrical control box with the primary wire, connect the upper heating box and the electrical control box with the secondary wire, the lower heating plate and the electrical control box, connect the upper heating plate and the electrical control box, and install temperature measuring elements in the lower heating plate and the electrical control box. Pay attention to the corresponding marks on the electrical control box when connecting the wires.

7. Connect the hydraulic plate to the pressure test pump with a high-pressure hose, then open the electronic control box and inject water into the hydraulic plate to the vulcanization pressure.